 Bad number 3 valve, Best shop for a stroker Engine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| wes |
 May 1 2026, 03:56 PM
Post
#1
|
|
wes  Group: Members Posts: 1,609 Joined: 8-December 07 From: Ukiah Ca Member No.: 8,436 Region Association: Northern California 
 |
I have done a leak down test on my 2370 stroker with a bad number three valve will not hold compression. I’m trying to decide who to have the work done by. I’ve thought about Jerry Woods in Campbell major racing experience. Also Soren Anderson of Santa Rosa. Wondering if anybody has advice or experience considering it’s a stroker, with either of them. Although I’m not planning on racing, I love the torque of this engine and want to make it right and I’m leaning on the idea of Jerry Woods. I’m also open to others. The engine was originally balanced and blueprinted by fat performance, and built in Virginia Beach by Abacus Racing and machine shop.
|
   |
 
|
  |
Replies(1 - 1)
| TRP |
May 1 2026, 06:59 PM
Post
#2
|
|
Member Group: Members Posts: 332 Joined: 2-September 23 From: Morgan Hill, CA Member No.: 27,559 Region Association: None
|
I would recommend Ken Jansen at Jansen Enterprise in Belmont, CA. He is very knowledgeable with these typeIV motors, honest, and dependable.
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st May 2026 - 08:38 PM |
Invision Power Board
v9.1.4 © 2026 IPS, Inc.